Is this too far gone

I tried replacing the hdmi port on my ps5. Tested it and the ps5 was detected but no image. Teared it down again to recheck and one of the pins was lose. In my attempt to resolder that single pin, I ended up making it worse. I finally removed the whole post due to having pins soldered together. Long story short, I removed it 3 times until I finally gave up. The masking started to come off and I accidentally teared off 4 pads when the solder wasn’t melting and got stucked to my iron. No I’m contemplating ordering a 180x lens with one of those square cameras from aliexpress as my issue was not being able to zoom in as much on the board due to using a cheap 40 dollar microscrope off Amazon. Looks like I would need to use jumpers which is something that’s technically difficult to do as was trying to avoid. What’s the verdict? Thank you for the input.